After lining the walls of the bathroom and making the screen under the bath, PVC panels remained. In addition, pieces of organes and aluminum corners were found on the farm. Well, here is one of the ways to solve the issue with a container for storing linen. Cutting of the mounting profile from PVC panels, aluminum rivets and transparent sealants were also useful. First, I cut out the walls of the future container specially made for these purposes with a cutter from an plexiglass. For this, a plexiglass of any color or polycarbonate is suitable, but not a cell phone is not tough enough.
The dimensions of the container, of course, is an individual matter. The edges of the cut walls were trimmed on a grinding machine. Then to the details that should go to the back wall of the container, a 2 mm drill drilled a number of holes for ventilation of the container. Having sawed off the duralumin corner profile of the desired length, put it to the future side wall of the container and drilled in both parts at the same time 03.2 mm holes for rivets with a torn rod.Having inserted the rivets into the holes, connected the parts using the ticks intended for this. According to this technology, on aluminum corners and rivets, he sequentially attached all four walls of the container to each other, and to them — the bottom carved from plastic trims.Now it was necessary to decorate the container in the style of decoration of the interior of the bathroom. For this, first from the residues of the finishing profile for PVC panels, I cut the parts of the required length.
It required a starting P-shaped profile, butt N-shaped, and the external angle. To prepare parts, you can use scissors for metal, but much more convenient — a special cut for plastic. Then, also on rivets, attached parts cut from the profile to the front and side walls of the container.PVC panels cut off the LWS corner grinding machine with fine saw.First closed the outer wall of the container with panels. Although the panels are inserted into the profile fixed by rivets, but so that they do not shift along the wall of the box (due to a small backlash in the joints), the back of the wall panels of two narrow stripes. The joints of the panels strengthened the H-shaped profile, which is just for this.At the end of the upper edges of the walls of the container, he launched the edging from the P-shaped profile.
For joining in the corners, the profile cut obliquely. Before installing the edging profiles, he also missed a transparent sealant, and before installation he missed a plumbing sealant. Since there were not so many scraps of panels, it was necessary to equip the overlays for the side then recorded them with a painting tape until the sealant dries out. To make the container more convenient to move, a handle was required. Two holes, two screws — and the handle is already in place.The container lid was made from the remnants of the panels, gluing parts cut from them on a plastic substrate. For stiffness, I strengthened the lid around the perimeter with the corners: from below — duralumin, and on top, for beauty, thin white plastic. This “sandwich” pulled M3 screws, and so that they did not perform much, cut off the excess of the drill with a diamond disk
.The linen capacity made in place remarkably fit into the interior of the bathroom. In height, the container fits under a towel with a sutor, and being pushed deeper under the bath, practically does not take up place. In order not to pull the container from under the bath every time, just move its lid.
————————————————————————————
Want to set the express payment terminal in your building or store on the most favorable terms? We recommend the Arendamest website